- #CHANGE LIGHTNING CONNECTOR IPHONE 5 FOR FREE#
- #CHANGE LIGHTNING CONNECTOR IPHONE 5 PRO#
- #CHANGE LIGHTNING CONNECTOR IPHONE 5 FREE#
#CHANGE LIGHTNING CONNECTOR IPHONE 5 PRO#
Lightning is the "new" connector supported by iPhone 5 and newer, iPad mini and newer, iPad (4th generation) and newer, up to but not including the 2018 iPad Pro line, ( iPad Pro (11-inch) and iPad Pro (12.9-inch) (3rd generation)), and iPod touch (5th generation) and newer. Use double-sided tape to replace the adhesive strips during reassembly.Lightning connector from aerial, front, top, and socket angles Once the old battery is removed, replace with yourīelow) and follow steps in reverse order to reassemble.
#CHANGE LIGHTNING CONNECTOR IPHONE 5 FREE#
Pull slowly and continuously until the battery is free, if this is not an option proceed with the below steps to free the battery. In some instances it may be possible to remove the battery from the phone simply by pulling on the plastic pull-tab. Using a plastic opening tool, gently pry upward on the battery connector to release it from the socket on the board.Remove the metal battery connector bracket.Label and place in a safe area for reassembly.
Screw (shown in orange) to release the metal battery connector bracket. The rear case, remove the one 1.8mm screw (show in red) and one 1.6mm Remove the front panel from the rear case.The best way to power cycle your phone is to disconnect and then If this occurs simply reconnect the cable and power cycle your Screen or white lines across the screen when you power your device back Has been known to pop off of its connector. NOTE: Be careful when reassembling your phone as the LCD data cable Use the flat end of a plastic opening tool or spudger to disconnect Do not pull or pry on the sockets on the logic board. Removal of the bracket easier, place in a safe area for reassembly.ĭuring the next steps be careful to only pry upwards on the cable connectors. Carefully remove the front panel assembly bracket from the logic board.Remove the three Phillips screws securing the front panel cableīracket, we suggest labeling and placing items in a safe area for.If you allow it to fall flat this will strain theĭisplay cables and their connections on the logic board and possibly result in damage or device issue. PLEASE NOTE: When doing this step you want to keep the front panel supported at a 90º angle (in relation to the rearĬase) until you remove it.There are several cables attached at the top of the phone. Do not try to completely remove the front panel from the rear. Pull the (home button) end of the front panel away from the rear case, take caution and use the top of the phone as a hinge.Using the plastic opening tool, continue prying around the outside of the front assembly detaching the clips along the left and right sides.Use the suction cup along with the plastic opening tool to free the Using a plastic opening tool, gently pry theīack case away (down) while continuing to pull up with the suction cup.Īre clips that hold the front panel to the back case so you may need to So the front panel assembly slightly separates from the back case.įront panel has a tight fit, so be sure to take your time and applyĬonstant, firm pressure. Hold the iPhone down with one hand, and pull up on the suction cup.Be sure the suction cup is pressed securely and has a tight seal.Press suction cup to the screen above the home button.Located on both sides of the lightning connector.
#CHANGE LIGHTNING CONNECTOR IPHONE 5 FOR FREE#
Please Note: Above tools are included for FREE when this replacement battery is purchased from. Use this detailed step-by-step repair guide to help you replace the 616-0610, 616-0611, 616-0613
0 kommentar(er)
